# Reflection and Transmission Coefficients

### After reading this section you will be able to do the following:

- Understand how reflection and transmission varies based on materials.
- Calculate reflection and transmission coefficients.

Waves are reflected at boundaries where there is a difference in impedances (Z) of the materials on each side of the boundary. This difference in Z is commonly referred to as the **impedance mismatch**. The greater the impedance mismatch, the greater the percentage of energy that will be reflected at the interface or boundary between one medium and another.

The fraction of the incident wave intensity that is reflected can be derived because particle velocity and local particle pressures must be continuous across the boundary. When the impedances of the materials on both sides of the boundary are known, the fraction of the incident wave intensity that is reflected can be calculated with the equation below. The value produced is known as the **reflection coefficient.** Multiplying the reflection coefficient by 100 yields the amount of energy reflected as a percentage of the original energy.

$R=\left(\frac{Z_{2}-Z_{1}}{Z_{2}+Z_{1}}\right)^{2}$

Since the amount of reflected energy plus the transmitted energy must equal the total amount of incident energy, the **transmission coefficient** is calculated by simply subtracting the reflection coefficient from one.

Formulations for reflection and transmission** coefficients** (pressure) are shown in the interactive applet below. Different materials may be selected or the material velocity and density may be altered to change the acoustic impedance of one or both materials. The red arrow represents reflected sound and the blue arrow represents transmitted sound.

Note that the reflection and transmission coefficients are often expressed in decibels (dB) to allow for large changes in signal strength to be more easily compared.

Using the applet above, note that the energy reflected at a water-stainless steel interface is 0.88 or 88%. The amount of energy transmitted into the second material is 0.12 or 12%. The amount of reflection and transmission energy in dB terms are -1.1 dB and -18.2 dB respectively. The negative sign indicates that individually, the amount of reflected and transmitted energy is smaller than the incident energy.

If reflection and transmission at interfaces is followed through the component, only a small percentage of the original energy makes it back to the transducer, even when loss by attenuation is ignored. For example, consider an immersion inspection of a steel block, like the one on the left. The sound energy leaves the transducer, travels through the water, encounters the front surface of the steel, encounters the back surface of the steel and reflects back through the front surface on its way back to the transducer. At the water steel interface (front surface), 12% of the energy is transmitted. At the back surface, 88% of the 12% that made it through the front surface is reflected. This is 10.6% of the intensity of the initial incident wave. As the wave exits the part back through the front surface, only 12% of 10.6 or 1.3% of the original energy is transmitted back to the transducer.

### Review:

- Waves are reflected at boundaries where there is a difference in impedances (Z) of the materials on each side of the boundary.
- Reflection and transmission coefficients are often expressed in dB.